Acoustical Panel Installation - Adhesive

 •  Sound Solutions for your Acoustical Challenges

SCOPE:

Adhesive mounting is ideally suited for applications requiring speed and ease of installation or flexibility to adjust to various field conditions. This type of installation requires no layout time for the installer due to therandom application of adhesive to the panels.

STEP 1

Wall surface to be clean and free of any surface obstructions.

STEP 2

Install leveling angles (supplied w/ panels) using appropriate mechanical fasteners.

***DO NOT INSTALL PANELS WITHOUT LEVELING ANGLES ***

The leveling angles are the primary panel support.

If panels installation is from floor-up leveling angles are not required.

STEP 3

Prepare panel for installation. Mark back of panel for field cutting { if required }. Carefully cut fiberglass from back of panel. Then cut covering surface leaving enough covering to allow for wrapping of the field cut are. Carefully apply adhesive to the cut-out fiberglass edges and panel back then fold the excess covering around the cut-out area edges and wrap to the back of the panel.

STEP 4

Apply " spots" { approx. 4 x 6" diameter } of panel mounting adhesive at random locations around perimeter and across the vertical and horizontal centers of the panel.

STEP 5

Position the panel on the leveling angle and press the panel to the wall to set the adhesive. Hold for approximately 30 seconds.

NOTES

When measuring for field cut-outs, be sure to reverse the dimensions as cuts will be made from the back panel.

adhesive illustration